Can anyone solve the issue of Tekla 2018 Crashing every time I try to Click on parts and create a part drawing or most buttons in the create drawings as it starts to load the goes black, freezes and then restarts/crashes??? ( I've updated my geforce driver and I'm on a gaming laptop that runs high powered Autocad, Advanced steel and all other software on windows 10/16gb/3ghz. Can Tekla or the software be adjusted to work?
Tekla 2018 Crashes at Create Drawings? (help)
19.06.2018 03:25
Same thing happens to me in tekla 2017i and 2018 but tekla 21.0 works just fine
...and can you tell me how to save a mode in version 21 which was created in 2018?
Any one know how to fix it?
This is Xin from madco. This might not be the real solution but temporary works if you rush to make the drawings for the Job.
I had the same issue that tekla crashed when make/open drawings. What I did is change the profile of the part to another similar one( like change W30x132 to W24x103). Then I can make the part/assembly drawings without crashing. I will later correct the part profile to the desired one.
Again I wish the tekla tech guys can read this and correct the bug. But try this if you have the same problem and rush to solve it.
The user has deleted this message
Hi, I had the same issue. Well I already have the solution to solve that. You must install the Environment to make the software run when it created Drawing.
When you open the Tekla at the first time, you must change the "Environmet:" to specified project like US metric or US imperial.
Same crash again and again . I am trying to create drawing / at the pictture point . Now it will crash .
I'm still struggling with this problem. Any solution yet?
Thanks in advance!
Can be from the License module ! Tekla guys can tell you ! Usually they give you a Service Pack to repair this issue. Happened to me at the version 20.
Same problem for me... Any solution for this?
Thanks
Hi,
do you get any error messages? Can you run the Event Viewer to see if there are any logs on the error? Instructions here: https://campus.tekla.com/forum/installing-licensing/installation-problem...
Hi guys when I want to create a drawing, Tekla Structures 2018 reboots. Have somebody found the solution?