2 posts
0
new
Go to last post
Valley angle in Hopper ?
24.02.2015 19:20

I had created a hopper but I need to bind the sides of the plate using an angle ( L angle say 75X75X6 ). But this can be generated only using a FLDPL profile as we have the angle between the adjacent sides are not 90 degrees in a hopper. My question is how can we easily find the angle between the two adjacent sides so that It would give the input to be fed to the FLDPL profile.

No Upvotes
It can be geometrically
Re: Valley angle in Hopper ? 14.04.2015 01:13

It can be geometrically calculated see link below
http://bulksolidsflow.com.au/program/free-design-programs/valley-angles

or cut sections to arrive at the true view to measure the angle

No Upvotes