3 posts
0
new
Go to last post
assembly position numbers
05.03.2014 14:21

Hi all, why always when you make mirror of reinforced object tekla makes new assembly position number? i got reinforced pad footing, everything works fine if i decide to copy footing (pos. number remains without changes). When i use mirror tekla decides to give new pos. for mirrored object?! Maybe it's posible to change setting or smth.? Thank you.

No Upvotes
Any comments? :(
Re: assembly position numbers 16.03.2014 18:35

Any comments? :(

No Upvotes
Well, when just looking at
Re: Any comments? :( 03.04.2014 16:18

Well, when just looking at the problem from the beginning, it sounds like it is doing what it is supposed to be doing. Everything in Tekla is numbered, a mirror of an assembly must be numbered separately from the original, otherwise you would have 2 of everything. Am I not correct?

No Upvotes